HP ProCurve 6120G/XG Manual page 447

ProCurve(config)# show filter
Traffic/Security Filters
IDX Filter Type
--- ------------ + -------------------
1 Source Port
2 Source Port
3 Source Port
4 Source Port
5 Source Port
6 Source Port
7 Source Port
8 Source Port
20 Source Port
21 Source Port
22 Source Port
23 Source Port
24 Source Port
25 Source Port
26 Source Port
Figure 11-7. Example of the show filter Command
Using the IDX value in the show filter command, we can see how traffic is
filtered on a specific port (Value).The two outputs below show a non-
accounting and an accounting switch port.
| Value
| 2
| 3
| 4
| 5
| 6
| 8
| 9
| 12
| 24
| 25
| 26
| 7
| 10
| 11
| 1
Traffic/Security Filters and Monitors
Filter Types and Operation
Indicates the port number or port­
trunk name of the source port or trunk
assigned to the filter.
An automatically assigned index
number used to identify the filter for
a detailed information listing. A filter
retains its assigned IDX number for
as long as the filter exists in the
switch. The switch assigns the
lowest available IDX number to a new
filter. This can result in a newer filter
having a lower IDX number than an
older filter if a previous (source-port
or named source-port) filter deletion
created a gap in the filter listing.
11-11