To Select The Remote Interface - HP 34401A User Manual

Chapter 4 Remote Interface Reference

To Select the Remote Interface

To Select the Remote Interface
The multimeter is shipped with both an
and an
The
the factory. See also "Remote Interface Selection," on page 92.
On/Off
Shift <
1 Turn on the front-panel menu.
A: MEAS MENU
<
<
2 Move across to the
E: I/O MENU
3 Move down a level and then across to the
2: INTERFACE
4 Move down to the "parameter" level to select the interface.
Use the left/right arrow keys to see the interface choices. Choose from
the following:
HP-IB / 488
Auto/Man
5 Save the change and turn off the menu.
ENTER
The interface selection is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
162
interface. Only one interface can be enabled at a time.
RS-232
interface is selected when the multimeter is shipped from
HP-IB
I/O MENU
or
HP-IB / 488
(
HP-IB IEEE-488
choice on this level.
INTERFACE
.
RS-232
) interface
command.