HP 34401A User Manual page 56

Chapter 3 Features and Functions
Measurement Configuration
5 digits
10.216,5
1
" " digit
2
This is the 10 Vdc range, 5
1
" " digit
2
-
045.23
This is the 100 mVdc range, 4
113.325,6 OHM
This is the 100 ohm range, 6
The resolution is stored in volatile memory; the multimeter sets the
resolution to 5
after a remote interface reset.
The resolution is fixed at 5
For dc and resistance measurements, changing the number of digits
does more than just change the resolution of the multimeter. It also
changes the integration time, which is the period the multimeter's
analog-to-digital (A/D) converter samples the input signal for a
measurement. See also "Integration Time," on page 57.
For ac measurements, the resolution is actually fixed at 6
If you select 4
two digits. The only way to control the reading rate for ac measurements
is by setting a trigger delay (see page 79).
For ratio measurements, the specified resolution applies to the signal
connected to the Input terminals.
VDC
1 digits are displayed.
2
mVDC
1 digits are displayed.
2
1 digits are displayed.
2
1 2 digits (for all functions) when power has been off or
1 2
digits for continuity and diode tests.
1 2 digits or 5 1 2 digits, the multimeter "masks" one or
3
1 2 digits.
55