To Set The Hp-Ib Address - HP 34401A User Manual

Chapter 4 Remote Interface Reference

To Set the HP-IB Address

To Set the HP-IB Address
Each device on the
address. You can set the multimeter's address to any value between
0 and 31. The address is set to " 22 " when the multimeter is shipped
from the factory. The address is displayed on the front panel when you
turn on the multimeter. See also "
On/Off
Shift <
1 Turn on the front-panel menu.
A: MEAS MENU
< <
2 Move across to the
E: I/O MENU
3 Move down a level to the
1: HP-IB ADDR
4 Move down to the "parameter" level to set the address.
Use the left/right and down/up arrow keys to change the address.
Auto/Man
5 Save the change and turn off the menu.
ENTER
The address is stored in non-volatile memory, and does not change when
power has been off or after a remote interface reset.
(
HP-IB IEEE-488
I/O MENU
22 ADDR
) interface must have a unique
Address," on page 91.
HP-IB
choice on this level.
command.
HP-IB ADDR
4
161