To Select The Programming Language - HP 34401A User Manual

Chapter 4 Remote Interface Reference

To Select the Programming Language

To Select the Programming Language
You can select one of three languages to program the multimeter
from the selected remote interface. The language is
the multimeter is shipped from the factory. See also "Programming
Language Selection," on page 94.
On/Off
Shift <
1 Turn on the front-panel menu.
A: MEAS MENU
< <
2 Move across to the
E: I/O MENU
<
3 Move down a level and then across to the
5: LANGUAGE
4 Move down to the "parameter" level to select the language.
Choose from one of the following: SCPI, HP 3478A, or Fluke 8840A.
SCPI
Auto/Man
5 Save the change and turn off the menu.
ENTER
The language selection is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
choice on this level.
I/O MENU
when
SCPI
command.
LANGUAGE
165
4