HP 34401A User Manual page 104

Remote Interface Reference
Command Summary, starting on page 105
’ Simplified Programming Overview, starting on page 112
The MEASure? and CONFigure Commands, starting on page 117
Measurement Configuration Commands, starting on page 121
Math Operation Commands, starting on page 124
Triggering, starting on page 127
Triggering Commands, starting on page 130
System-Related Commands, starting on page 132
The SCPI Status Model, starting on page 134
Status Reporting Commands, starting on page 144
Calibration Commands, on page 146
RS-232 Interface Configuration, starting on page 148
RS-232 Interface Commands, on page 153
’
An Introduction to the SCPI Language, starting on page 154
Output Data Formats, on page 159
Using Device Clear to Halt Measurements, on page 160
TALK ONLY for Printers, on page 160
To Set the HP-IB Address, on page 161
To Select the Remote Interface, on page 162
To Set the Baud Rate, on page 163
To Set the Parity, on page 164
To Select the Programming Language, on page 165
Alternate Programming Language Compatibility, starting on page 166
SCPI Compliance Information, on page 168
IEEE-488 Compliance Information, on page 169
If you are a first-time user of the SCPI language, you may want to refer to these sections
to become familiar with the language before attempting to program the multimeter.
104