Oneida Air Systems Dust Deputy AXD001004 Owner's Manual page 9

VIII. Other Options for Securing Dust Deputy® Deluxe to Vacuum
Strap to Vacuum
Velcro to Dolly
Bolt Bucket to Dolly
15
Weight in Bottom of Drum - Works best
for permanent locations.
Bolt to Attached Platform - This works
best with large wet / dry vacuum.
Home-Built Cart
Dust Deputy® Owner's Manual © 2010
V. Assembly Instructions for Deluxe Dust Deputy® Kit
4.) Position foam block on marks and drill two holes (upper
and lower) through foam block and bucket (Fig.6). Put the two
supplied carriage bolts through the large washers and then
through the bucket from the inside.
5.) Mark on shop vacuum where bolts will go through (Fig. 7).
6.) Carefully drill through wall of vacuum (Fig. 8). If you ever
want to remove the Dust Deputy from your shop vacuum, you
can easily seal the holes in your vac with a bolt, washer, nut
and silicone if you desire.
7.) Put bolts through the holes in vacuum and fasten inside
of shop vacuum body with another washer and bolt as shown
in Fig. 9.
Dust Deputy® Owner's Manual © 2010
Fig. 6
Fig. 7
Fig. 8
Inside shop
vacuum
Fig. 9
8