Advertisement
Quick Links
To collect dust safely and efficiently
Build your own
The Multi-Cyclone DIY Dust Deputy
twice the suction of a single vacuum for bench top tools.
www.oneida-air.com
Multi Cyclone DIY
Dust Deputy Kit
w w w . o n e i d a - a i r . c o m
Super Cyclonic Dust Collector
AXD990003
Revised 8-8-2011
™
TM
Collector gives you
Copyright 2011 Oneida Air Systems, Inc.
ZBI990003
TM
Advertisement
Related Manuals for Oneida Air Systems Dust Deputy AXD990003
Summary of Contents for Oneida Air Systems Dust Deputy AXD990003
- Page 1 To collect dust safely and efficiently Super Cyclonic Dust Collector Build your own The Multi-Cyclone DIY Dust Deputy Collector gives you twice the suction of a single vacuum for bench top tools. AXD990003 Revised 8-8-2011 Copyright 2011 Oneida Air Systems, Inc. www.oneida-air.com...
-
Page 2: Exploded View
Dust Bin Lid with holes cut (1) 4 inch diameter 90 degree elbow for Dust Deputys Part D Hardware and extra caulk Optional: 3/4” diameter Router Bit and Circle Cutting Jig. Exploded View Copyright 2011 Oneida Air Systems, Inc. www.oneida-air.com... - Page 3 4 inches apart. Part A3 (See Diagram 1) Exact placement is not critical as long as they are located at least 2” from any edge. Copyright 2011 Oneida Air Systems, Inc. www.oneida-air.com...
-
Page 4: Bottom View
3 inches inside the air box. All edges are glued or caulked so as to provide for air tight seals. All 30 degree ends overlap. Part B1, B2, A1, A2, A3 Bottom View Copyright 2011 Oneida Air Systems, Inc. www.oneida-air.com... - Page 5 1”. Mark for cutting but do not cut too short. It is ok for some of the side air ports to extend into the 4” PVC Air Pipe, this is necessary for silicone caulking and sealing. Cut off/shorten side ports of Dust Deputys. Diagram 3 Copyright 2011 Oneida Air Systems, Inc. www.oneida-air.com...
- Page 6 The required foam gasket will compress the lid to the bin and form an airtight seal which is required for dust separation in the Dust Deputy Cyclones. Copyright 2011 Oneida Air Systems, Inc. www.oneida-air.com...
- Page 7 3” inch holes on top of the Triangular Air Box as well as the outer edges of the 3” inch reducer, install into holes. Apply any additional sealant if necessary. Copyright 2011 Oneida Air Systems, Inc. www.oneida-air.com...