Oneida Air Systems Dust Deputy AXD001004 Owner's Manual page 11

VII. Installing the Dust Bagger
Attach vacuum hose elbow
with valve to vacuum as
shown in Fig. 5. Push in-
cluded plastic tubing into 1/4"
tubing elbow. (Fig. 1)
Fig.1
Push other end of tubing into
1/4" tubing valve. (Fig. 2)
Tubing can be cut to desired
length.
To remove tubing from valve,
you must push end of valve
in to release the grip. See ar-
row in Fig. 2. Ensure valve is
open when using bags. Valve
Fig.2
shown in open position.
Place included fi lter into han-
dle space of top valve inside
of box. (Fig. 3) This prevents
bag from being sucked into
valve and prevents dust from
entering valve if used without
bag.
Fig.3
Place bag into box, tucking
Fig.4
into corners and folding top of
bag over top of box. (Fig. 4)
13
Fig.5
Place top on box and latch down,
attach your hoses to the Dust
Deputy® inlet and outlet and
you're ready to go! (Fig.5)
Fig.6
If you want to run the Dust Deputy®
without the bag, you must shut the
valve by turning the valve handle
90 degrees. The system must be
air-tight to operate properly. Fig.6
shows valve in open position.
Note: Before resuming using
plastic bags you must vacuum
off the foam fi lter (Fig. 3) so air
fl ow is not restricted.
Dust Deputy® Owner's Manual © 2010
V. Assembly Instructions for Deluxe Dust Deputy® Kit
If hoses are not tight on the inlet, or keep
pulling off, use the included Hose Reten-
tion Ring or the included clamp or both as
shown below.
Hose Retention Ring
Shown with optional single cart. See
accessories page.
Dust Deputy® Owner's Manual © 2010
Make sure larger
diameter hoses are
pushed up so they fi t
tightly over the inlet
Hose Clamp
Shown with optional double cart. See
accessories page.
10