Oneida Air Systems Dust Deputy AXD001004 Owner's Manual page 10

V. Assembly Instructions for Deluxe Dust Deputy® Kit
The Dust Deputy® is made of static dissipating
1.) Place supplied gasket on plastic drum top, lining up
holes in gasket with holes in lid.
2.) Install copper tape then place bolt through washer
then put bolt through hole in base of cyclone. Secure
with nut underneath.
For additional static
reduction, install copper
tape as shown.
Cover bolt hole and use the
bolt for the grounding wire
anchor.
Bolt
Wire
Nut
Gasket
For added grounding, attach wire to bolt between bolt head
and washer, then attach another washer to end of wire. Wire
must be long enough for washer to lie fl at on fl oor.
This hardware not provided.
9
plastic.
3.) Snap lid tightly on drum and
you're ready to go.
A
4.) Attach provided hose from shop
vacuum to top outlet on cyclone (A).
Use shop vacuum hose to attach to
tools. (B).
Use included elbow on the shop vacuum
inlet or on the outlet of the cyclone.
(Ring Terminal Recommended)
Elbow
Washer
Base
Washer
Floor
Dust Deputy® Owner's Manual © 2010
VIII. Possible Ways to Attach Dust Deputy® Deluxe to Shop Vacuums
B
Note: For better mobility and stability use the included 3 casters as shown in the
assembly instructions.
Dust Deputy® Owner's Manual © 2010
You may want to attach your Dust Deputy
to your shop vacuum for mobility, conve-
nience or stability. There is no defi nitive
way to attach the Dust Deputy to a shop
vacuum. It will vary with vacuum type and
intended use. These are just a few exam-
ples of possible ways it may be done.
Cut the provided foam block in half. Drill
two 1/4" holes through bucket, blocks
and vacuum as shown, then using
provided long bolts, washers and nuts,
attach bucket to vac.
Use the foam blocks as spacers
between the vac and bucket then put
the assembled Dust Deputy into the at-
tached bucket to hold it securely to the
vacuum. Attach the appropriate hoses
and you're ready to go.
Some vacuums may only require one foam
block to attach the bucket. This may be
determined by vacuum body shape.
Cut the provided foam block to size. Drill two
1/4" holes through bucket, blocks and vacuum
as shown, then using provided long bolts,
washers and nuts, attach bucket to vac.
Use the foam block as upper spacer between
the vac and bucket then put the assembled
Dust Deputy into the attached bucket to hold
it securely to the vacuum. Attach the appropri-
ate hoses and you're ready to go.
The mounting is only limited by your
imagination.
To prevent tipping, install
provided casters.
14