Table of Contents
Advertisement
Source Connections
Connecting a Composite Video source to Port 1
Composite video signals coming from a VCR, OFF air signal decoder and so on can be connected to Port 1.
75 W Termination Switch for Video
Terminate the video input of the projector using the 75 Ω switch next to the video input, when the projector operates alone or when
the projector is the last unit in a loop-through configuration.
The switch is set to "ON"
The switch is set to "OFF"
How to select Composite Video source:
Select the Composite Video source input by pressing the numeric button 1 on the RCU or the local keypad.
Connecting a S-Video (or Composite Video) source to Port 2
Separate Y-luma/C-chroma signals for higher quality playback of Super VHS signals can be connected to Port 2 . A composite video
can also be connected to this port.
In case of using Port 2 for connecting the Composite Video, the selection of this source have to be done inside the "Picture Tuning"
menu. Please refer to the Owner's Manual of this projector.
75 W Termination Switch for S-video
Terminate the S-video input of the projector using the 75 Ω switch next to the S-video input when the projector operates alone or
when the projector is the last unit in a loop-through configuration.
The switch is set to "ON"
The switch is set to "OFF"
6-2
:
signal terminated.
:
signal not terminated.
:
signal terminated.
:
signal not terminated.
5976257 BARCOREALITY 909 16032001
Advertisement
Table of Contents
