Garmin G3X Pilot's Manual page 384

AFCS
1
ALT Mode
APPROACH
Expecting vectors for ILS approach into KCOS
NOTE: If an approach contains a DME arc, the arc must be flown in Navigation
Mode with the GFC 3X. When receiving vectors from ATC, Navigation Mode
must be selected prior to intercepting the ARC.
Flying an ILS approach:
1) Transition from GPS Navigation Mode to Heading Select Mode.
a) EXTERNAL NAVIGATOR: Tune and activate the desired localizer
frequency.
b) EXTERNAL NAVIGATOR: Select the Runway 35L ILS approach for
KCOS and select 'VECTORS' for the transition. Load and activate the
approach into the flight plan.
c) G3X: From the PFD or PFD Page, press the HDG Softkey (if necessary).
The Heading Box is highlighted. Turn the FMS Joystick to select the
desired heading, and press the FMS Joystick, to complying with ATC
vectors.
d) GMC 305: Press the HDG Key. The autopilot turns the aircraft to the
desired heading.
Or: G3X: Press the AP HDG Softkey. The autopilot turns the aircraft to the
desired heading.
e) Use Heading Select Mode to comply with ATC vectors as requested.
362
TOD
Cruise Altitude of 12,000 MSL
2
VNAV Target Altitude of 10,000 MSL
VNAV Descent
Garmin G3X Pilot's Guide
3
BOD
ALT Mode
Selected Altitude (set below VNAV Target Altitude)
Along-track Offset, 3 nm before OPSHN
3 nm
190-01115-00 Rev. K