Switching From Standby Mode To Operating Mode - Garmin G3X Pilot's Manual

OPERATION
NOTE: The GTS 800 automatically transitions from STANDBY to OPERATE
mode eight seconds after takeoff. The unit also automatically transitions
from OPERATE to STANDBY mode 24 seconds after landing.
After power-up, the GTS 800 is in Standby Mode. The GTS 800 must be in Operating
Mode for traffic to be displayed and for TAs to be issued.
Pressing the OPERATE Softkey allows the traffic unit to switch from Standby Mode
to Operating Mode as necessary. Pressing the STANDBY Softkey forces the unit into
Standby Mode.
Switching from operating mode to standby mode:
On the Traffic Page, select the STANDBY Softkey

Switching from standby mode to operating mode:

On the Traffic Page, press the OPERATE Softkey
Changing the altitude range:
1) On the Traffic Page, select the ALT MODE Softkey.
2) Press one of the following Softkeys:
• ABOVE: Displays non-threat and proximity traffic from 9000 feet
above the aircraft to 2700 feet below the aircraft. Typically used during
climb phase of flight.
• NORMAL: Displays non-threat and proximity traffic from 2700 feet
above the aircraft to 2700 feet below the aircraft. Typically used during
enroute phase of flight.
• BELOW: Displays non-threat and proximity traffic from 2700 feet
above the aircraft to 9000 feet below the aircraft. Typically used during
descent phase of flight.
• UNREST (unrestricted): All traffic is displayed from 9900 feet above
and 9900 feet below the aircraft.
3) To return to the Traffic Page, press the BACK Softkey.
190-01115-00 Rev. K Garmin G3X Pilot's Guide
Hazard Avoidance
249