(8. 4) Change Of Vertical Inversion Setting; (8. 5) Change Of Horizontal Inversion Setting; (8. 6) Switching Of Inversion Mode Display; (8. 7) Change Of Binning Setting - Toshiba IK-HD3D Instruction Manual

(8. 4) Change of vertical inversion setting
Move the "
(8. 5) Change of horizontal inversion setting
Move the "
(8. 6) Switching of inversion mode display
Move the "
When ON is set, the setting status of vertical/horizontal inversion is displayed in the lower right part of the screen.
(8. 7) Change of binning setting
This is a function for increasing the sensitivity by adding pixels for horizontal and vertical directions.
Move the "
Note:
Turning of binning setting ON (effective) lowers the resolution.
(8. 8) Change of monitor receiver types
Move the "
(8. 9) Change of I/P mode
Switching between Interlace and Progressive is performed.
Move the "
Note:
No image is displayed on the monitor that is not in the correct setting mode. In that case, refer to the item 6.6
"Switching of I/P Modes" to return the mode to the original one.
(8. 10) Changing RS-232C baud rate
Move the "
↓V···Vertical inversion is effective.
→H···Horizontal inversion is effective.
↓V→H
29