Displaying And Operating Traffic (Tas Systems); Switching From Standby Mode To Operating Mode - Garmin GTN 750 Pilot's Manual

Pilot's guide
Hide thumbs Also See for GTN 750:
Table of Contents

Advertisement

10.2.2
Foreword
The unit must be in Operating mode for traffic to be displayed. The ability to
switch from Standby to Operating mode on the ground is especially useful for
Getting
Started
scanning the airspace around the airport before takeoff.
Audio &
Xpdr Ctrl
Com/Nav
Non-Threat
Traffic
FPL
Direct-To
Proc
Range Ring Distance
Traffic Status Key
Charts
(Operate/Standby)
Wpt Info
Map
10.2.2.1
Traffic
Terrain
Weather
Nearest
Music
Utilities
NOTE: Not all TAS systems can be set to "Standby" mode while in the
air.
System
The Traffic Page shows surrounding TAS traffic data in relation to the aircraft' s
current position and altitude without basemap clutter. Aircraft orientation is
Messages
always heading up unless no valid heading is received. The Traffic Status is
Symbols
annunciated in the lower left corner and the Altitude Filter is annunciated in the
lower right corner.
Appendix
10-12
Index

Displaying and Operating Traffic (TAS Systems)

Ownship
Position
Figure 10-6 Traffic Page

Switching from Standby Mode to Operating Mode

1. From the Home page, touch the Traffic key.
2. Confirm TAS is in Operating Mode.
3. Touch the Traffic Status key to toggle between Operate and
Standby mode.
4. Touch the Altitude Filter key to change the altitude
volume.
Garmin GTN 725/750 Pilot's Guide
Heading
Annunciation
Traffic
Proximity
Advisory
Range Rings
Altitude Filter
190-01007-03 Rev. B

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gtn 725

Table of Contents