Preparation; Installing / Exchanging Batteries; Setting Up The Scale - A&D SJ-3000WP Instruction Manual

3.1. Installing / Exchanging batteries

The batteries are not included with the product. Prepare 6 x "D" size (R20P or LR20)
dry-cell batteries.
When the
exchange the old batteries with new ones.
1. Loosen the screws for securing the
battery cover
screwdriver, and remove the battery
cover.
2. Remove all the old batteries from the
battery compartment.
3. Install six new
according to the + and - indicators of
polarity in the battery compartment.
4. Close the battery cover, and tighten the
screws for securing the battery cover.
CAUTION - Do not mix used and new batteries. Do not mix the different types
of batteries. That may cause damage to the batteries or the scale.
- Take care of the polarity of batteries. The polarity marks are shown
in the battery compartment.

3.2. Setting up the scale

CAUTION Avoid installing the scale in direct sunlight, that may cause
discoloration or malfunctions. Place your SJ-WP on a firm weighing
table so that the scale is level. The scale will not perform accurately
when it is not level.
Place the scale on a firm surface and adjust the feet so that the bubble of the
sprit level is in the center of the circle.

3. PREPARATION

mark is displayed,
using the provided
batteries properly
Battery
cover
4
Screw for
securing
Six new
batteries
(R20P/ LR20
/ D size)
Old
batteries
OK NG