Removing The Cfp Transceiver - Cisco ASR 9000 Series Installation Manual

Removing the CFP Transceiver

Gently tighten the two captive installation screws on the transceiver to secure the CFP transceiver in the
Step 6
socket. (See
Figure 1-47
Step 7 Reinstall the dust plug into the CFP transceiver's optical bore until you are ready to attach the network
interface cable.
When you are ready to attach the network cable interface, remove the dust plugs and inspect and clean
Step 8
fiber connector end faces, and then immediately attach the network interface cable connectors into the
CFP transceiver optical bores. (See
For complete information on inspecting and cleaning fiber-optic connections, see the
Fiber-Optic Connectors" section on page
Figure 1-48
SC connector
Network interface
Removing the CFP Transceiver
The CFP transceiver is a static-sensitive device. Always use an ESD wrist strap or similar individual
Caution
grounding device when handling the CFP transceivers or coming into contact with the modules.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
1-86
Figure 1-47.)
Securing the CFP Transceiver Module
Cabling an Optical CFP Transceiver Module with SC Connectors
L I N
K
cable
Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
Figure 1-48.)
1-104.
1
2
L I N
K
A C
T I
V E
"Cleaning
OL-17500-08