Cabling A 10-Gigabit Ethernet Xfp Transceiver; Cisco 40-Gigabit And 100-Gigabit Ethernet Cfp Transceiver Modules Installation; Figure 1-43 Cabling A10-Gigabit Ethernet Xfp Transceiver Module - Cisco ASR 9000 Series Installation Manual

Cisco 40-Gigabit and 100-Gigabit Ethernet CFP Transceiver Modules Installation

Cabling a 10-Gigabit Ethernet XFP Transceiver

Use this procedure to cable 10-Gigabit Ethernet XFP transceivers.
Note Before removing the dust plugs and making any optical connections, follow these guidelines:
•
•
•
Remove the dust plugs from the optical network interface cable LC connectors (see
Step 1
the dust plugs for future use.
Inspect and clean the LC connector's fiber-optic end faces.
Step 2
Remove the dust plugs from the XFP transceiver module optical bores.
Step 3
Immediately attach the network interface cable LC connectors to the XFP transceiver module (see
Step 4
Figure 1-43
Figure 1-43
Cisco 40-Gigabit and 100-Gigabit Ethernet CFP Transceiver
Modules Installation
This section provides the installation, cabling, and removal instructions for the Cisco 40-Gigabit and
100-Gigabit C Form-factor Pluggable (CFP) transceiver modules. The modules are hot-swappable
input/output (I/O) devices that connect the system's module port electrical circuitry with either a copper
or a fiber-optic network.
This section contains these sections:
•
•
•
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
1-82
Always keep the protective dust plugs on the unplugged fiber-optic cable connectors and the
transceiver optical bores until you are ready to make a connection.
Always inspect and clean the LC connector end faces just before making any connections. See the
"Cleaning Fiber-Optic Connectors" section on page
Always grasp the LC connector housing to plug or unplug a fiber-optic cable.
for an illustration of cabling the XFP transceiver module).
Cabling a10-Gigabit Ethernet XFP Transceiver Module
Overview, page 1-83
Required Tools, page 1-84
Installing the CFP Transceiver, page 1-84
Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
1-104.
A /L
0
A /L
1
Figure 1-41). Save
OL-17500-08