Figure 1-28 Installing A Bale Clasp Sfp Module Into A Port - Cisco ASR 9000 Series Installation Manual

Installing and Removing SFP Modules
Figure 1-28
Note When installing an SFP or SFP+ module, you should hear a click as the triangular pin on the bottom of
the SFP module snaps into the hole in the receptacle, indicating that the module is correctly seated and
secured in the receptacle. Verify that the SFP modules are completely seated and secured in their
assigned receptacles on the line card by firmly pushing on each SFP module.
Removing a Bale Clasp SFP or SFP+ Module
To remove this type of SFP or SFP+ module, follow these steps:
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Disconnect and remove all interface cables from the ports; note the current connections of the cables to
Step 2
the ports on the line card.
Open the bale clasp on the SFP module with your index finger in a downward direction, as shown in
Step 3
Figure
flat-blade screwdriver or other long, narrow instrument to open the bale clasp.
Step 4 Grasp the SFP module between your thumb and index finger and carefully remove it from the port, as
shown in
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
1-70
Installing a Bale Clasp SFP Module into a Port
1-29. If the bale clasp is obstructed and you cannot use your index finger to open it, use a small
Figure 1-29.
Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
1
0
3
5
7
9
2
4
6
8
OL-17500-08