4-Port 10-Gigabit Ethernet Modular Port Adapter - Cisco ASR 9000 Series Installation Manual

Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
Table 1-6
Table 1-6
LED Label
A/L
STATUS

4-Port 10-Gigabit Ethernet Modular Port Adapter

The 4-Port 10-Gigabit Ethernet modular port adapter provides four cages for XFP Ethernet optical
interface modules that operate at a rate of 10 Gbps. The four XFP modules can be 10-Gigabit Ethernet
multimode or single mode connections (see
Each XFP cage on the 4-Port 10-Gigabit Ethernet modular port adapter has an adjacent A/L (Active/link)
LED visible on the front panel. The A/L LED indicates the status of the associated XFP port, as
described in
Refer to
OL-17500-08
describes the 2-Port 10-Gigabit Ethernet modular port adapter LEDs.
2-Port 10-Gigabit Ethernet Modular Port Adapter LEDs
Color State
Off Off
Green On
Amber On
Off Off
Green On
Amber On
Table 1-7.
Figure 1-14 below for an example of the 4-Port 10-Gigabit Ethernet modular port adapter.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Meaning
Port is not enabled.
Port is enabled and the link is up. The MPA A/L
(Active/Link) LED will blink green when there is traffic
activity.
Port is enabled and the link is down.
Modular port adapter power is off.
Modular port adapter is ready and operational.
Modular port adapter power is on and good, and the
modular port adapter is being configured.
Table A-6).
Preparing for Installation
1-33