Table of Contents
Advertisement
Removing and Installing the PA-POS-1OC3
This chapter describes how to remove the PA-POS-1OC3 from supported platforms, how to install a new
or replacement port adapter, and how to connect cables.
This chapter contains the following sections:
•
•
•
•
•
•
Before you begin installation, read the
parts and tools required for installation.
Handling Port Adapters
Each port adapter circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge
(ESD) damage.
When a port adapter slot is not in use, a blank port adapter must fill the empty slot to allow the router or
Note
switch to conform to electromagnetic interference (EMI) emissions requirements and to allow proper
airflow across the port adapters. If you plan to install a new port adapter in a slot that is not in use, you
must first remove the blank port adapter.
When powering off the router, wait a minimum of 30 seconds before powering it on again.
Caution
OL-6514-04
Handling Port Adapters, page 3-1
Online Insertion and Removal, page 3-2
Warnings and Cautions, page 3-3
Port Adapter Removal and Installation, page 3-4
Connecting PA-POS-1OC3 Interface Cables, page 3-13
Replacing the SFP Optics Module, page 3-14
C H A P T E R
"Required Tools and Equipment" section on page 2-1
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
3
for a list of
3-1
Advertisement
Table of Contents
