Chapter 3 Removing And Installing Line Cards; Installation Overview - Cisco 7304 Installation And Configuration Manual

Removing and Installing Line Cards
This chapter describes how to remove the 6E3 line card from supported platforms and also how to install
a new or replacement line card. This chapter contains the following sections:
•
•
•
•
•
•

Installation Overview

Each line card circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge (ESD)
damage.
When a line card slot is not in use, a blank line card must fill the empty slot to allow the router to conform
Note
to electromagnetic interference (EMI) emissions requirements and to allow proper airflow across the line
cards. If you plan to install a new line card in a slot that is not in use, you must first remove the blank
line card.
OL-5061-01
Installation Overview, page 3-1
Handling Line Cards, page 3-2
Online Insertion and Removal, page 3-2
Warnings and Cautions, page 3-3
Line Card Removal and Installation, page 3-3
Connecting a SMB Cable, page 3-5
Cisco 7304 6-Port Clear Channel E3 Line Card Installation and Configuration
C H A P T E R
3
3-1