8-Port 10-Gigabit Ethernet Modular Port Adapter - Cisco ASR 9000 Series Installation Manual

Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
Table 1-7
Table 1-7
LED Label
A/L
STATUS

8-Port 10-Gigabit Ethernet Modular Port Adapter

The 8-Port 10-Gigabit Ethernet modular port adapter provides eight cages for SFP+ Ethernet optical
interface modules that operate at a rate of 10 Gbps.
The 8-Port 10-Gigabit Ethernet modular port adapter has the following guidelines and limitations:
•
•
•
Each SFP+ cage on the 8-Port 10-Gigabit Ethernet modular port adapter has an adjacent A/L
(Active/Link) LED visible on the front panel. The A/L (Active/Link) LED indicates the status of the
associated SFP+ port, as described in
Refer to
OL-17500-08
describes the 4-Port 10-Gigabit Ethernet modular port adapter LEDs.
4-Port 10-Gigabit Ethernet Modular Port Adapter LEDs
Color
Off
Green
Amber
Off
Green
Amber
The 8-Port 10-Gigabit Ethernet modular port adapter is supported on the 160 Gigabyte Modular Line
Card only (A9K-MOD160-TR and A9K-MOD160-SE).
The 8-Port 10-Gigabit Ethernet modular port adapter is not supported on the 80 Gigabyte Modular
Line Card (A9K-MOD80-TR and A9K-MOD80-SE).
The 8-Port 10-Gigabit Ethernet modular port adapter is not supported on the ASR 9001.
Figure 1-15 below for an example of the 8-Port 10-Gigabit Ethernet modular port adapter.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
State Meaning
Off Port is not enabled.
On Port is enabled and the link is up. The MPA A/L
(Active/Link) LED will blink green when there is traffic
activity.
On Port is enabled and the link is down.
Off Modular port adapter power is off.
On Modular port adapter is ready and operational.
On Modular port adapter power is on and good, and the
modular port adapter is being configured.
Table 1-8.
Preparing for Installation
1-35