Line Card Cable Management; Figure 1-54 Removing The 40-Gigabit Qsfp+ Transceiver Module - Cisco ASR 9000 Series Installation Manual

Line Card Cable Management

For QSFP+ transceivers equipped with a bail-clasp latch (See
Step 2
a.
b.
c.
For QSFP+ transceivers equipped with a pull tab latch (See
Step 3
a.
b.
c.
Place the QSFP+ transceiver into an antistatic bag.
Step 4
Figure 1-54
Line Card Cable Management
Note The illustrations in this section show one type of line card, but the line card cable-management
procedures in this section are the same regardless of the specific line card.
Cisco ASR 9000 Series Routers include a cable-management system that organizes the interface cables
entering and exiting the router, keeping them out of the way and free of sharp bends.
Excessive bending of interface cables can damage the cables.
Caution
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
1-94
Pivot the bail-clasp down to the horizontal position.
Immediately install the dust plug into the transceivers optical bore.
Grasp the sides of the QSFP+ transceiver and slide it out of the module socket.
Immediately install the dust plug into the transceiver's optical bore.
Grasp the tab and gently pull to release the transceiver from the socket.
Slide the transceiver out of the socket.
Removing the 40-Gigabit QSFP+ Transceiver Module
Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
Figure 1-54, top view):
Figure 1-54, bottom view):
OL-17500-08