System; Connecting Port Adapter Cables; Connecting I/O Cables; Installing A Port Adapter, Usb Flash Memory Module, Or Sfp Module That Did Not Ship In The System - Cisco CISCO7201 Installation And Configuration Manual

Installing a Port Adapter, USB Flash Memory Module, or SFP Module That Did Not Ship in the System

Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held
Step 7
firmly to the chassis. Do not overtighten the screws.
Step 8 Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure
an adequate chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the following cabling
sections for information on attaching cables.
Installing a Port Adapter, USB Flash Memory Module, or SFP
Module That Did Not Ship in the System
For information on installing a port adapter that did not ship in the system, see the
Installing a Port Adapter or Service Adapter" section on page
Documentation Roadmap for a linked listing to all online port adapter documentation.
For information on installing a USB Flash memory module that did not ship in the system, see the
"Removing and Installing a USB Flash Memory Module or USB eToken Pro Key" section on page
For information on installing an SFP module that did not ship in the system, see the
Installing an SFP Module" section on page

Connecting Port Adapter Cables

The instructions for connecting the cables for the port adapter installed in the Cisco 7201 router are
contained in the respective configuration notes for each port adapter. For example, if you are connecting
the optical fiber cables for the PA-POS-OC3 port adapter, refer to the PA-POS-OC3 Packet OC-3 Port
Adapter Installation and Configuration guide at
http://www.cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/pos/pa-pos-oc3_i
nstall_config/paposoc3.html.
Port adapter documents are also available on the Cisco Documentation DVD.

Connecting I/O Cables

This section contains input/output (I/O) connection equipment information for the native Gigabit
Ethernet, Fast Ethernet Management, console, and auxiliary ports.
Warning The ports labeled "Ethernet," "10BaseT," "Token Ring," "Console," and "AUX" are safety extra-low
voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits. Because the
BRI circuits are treated like telephone-network voltage, avoid connecting the SELV circuit to the
telephone network voltage (TNV) circuits. Statement 22
Cisco 7201 Installation and Configuration Guide
2-14
Chapter 2
4-5. Also see the Cisco 7201 Port Adapter
4-2.
Installing the Cisco 7201 Router
"Removing and
4-4.
"Removing and
OL-11364-04