Wireless 802.11 Security Settings - Intermec PM23c User Manual

Appendix B — Default Settings

Wireless 802.11 Security Settings

132
Wireless 802.11 Network Settings (Continued)
Setting Description
Default Router Sets the IP address of a router that is
used when a device sends a packet to
another subnet or to an unknown
destination.
DHCP Response Sets if the printer receives DHCP
responses by broadcast or unicast.
(IPv6) IP Sets how the printer obtains an IP
Assignment address (for IPv6 networks).
Method
(IPv6) IP Address Sets the unique network-level address
that is assigned to each device in an
IPv6 network.
This section describes the 802.11 security settings. To view these
settings:
• From the printer Main Menu, select Settings > Communications
> Wireless 802.11 > Security.
• From the printer web page, click the Configure tab >
Communications > Wireless 802.11.
Wireless 802.11 Security Settings
Setting Description
Security Type Selects the protocol the radio uses to
verify its identity and makes sure that
it is authorized to communicate on
the wireless network.
Association Selects the security method that the
radio uses to get access to the wireless
network.
Pre-Shared Key Defines the passphrase that allows
the radio to authenticate over the
wireless network (for both WPA and
WPA2 security). Range is 8 to 64
characters.
PM23c, PM43, and PM43c Mid-Range Printer User Manual
Default
0.0.0.0
Broadcast
Automatic
Automatic
Default
None
Open/WEP
None