Front Feed Table - GBC F - 160 CE Operation And Maintenance Manual

Safety
Press RESET located on the right leg at the front
of the machine. Refer to Figure 1.5.3 Machine reset.
Figure 1.5.3 Machine rest
Machine reset

1.6 Front feed table

The front feed table must be in proper position
for the laminator to operate in auto run. Refer to Figure
1.6.1 Front feed table.
When the key is removed from the interlock, the
laminator will stop. With the table removed, the laminator
will operate using the variable speed footswitch.
Page 1 - 6
F - 160CE Operation and Maintenance Manual
Figure 1.6.1 Front feed table
To continue operation, press STOP.
5.0
SPEED
SAFETY
Then press GO.
5.0
SPEED
SAFETY
© GBC Films Group April 2000
G O
F W D
REV
STOP
G O
F W D
REV
STOP