Chart 8 - One Pass Mount - GBC F - 160 CE Operation And Maintenance Manual

Applications
Parameter Chart 8 - One pass mount and laminate
U P P E R U N W I N D :
L O W E R U N W I N D :
T O P T E M P .
240
G A P
1/4
00.0
S P E E D
D O W N
Upper unwind material may be sibstituted with similar product. Substrate can vary. Top temperature will vary
slighly between 240 - 260
thickness. Pressure will be determined by the operator. Speed is not indicated in Footswitch mode. Because
the process is described from the front of the laminator, motor direction is FWD and the pull rolls are not
required for this application.
Page 6 - 20
MATERIALS
3 mil Octiva Gloss
N / A
TEMPERATURE
GAP & PRESSURE
MOTOR DIRECTION & SPEED
PULL ROLL SETTINGS
U P
NOTES
o
F depending on laminate thickness. Gap will be dependent on the substrate
F - 160 CE Operation and Maintenance Manual
S U B S T R A T E : 1/4" Foam Core
PRINTS : Electrostatic images
B O T . T E M P .
68
P R E S S U R E
= Panel
SOLID
G O
= Footswitch
F L A SH I N G
G O
P R E S S U R E
© GBC Films Group April 2000
F W D
R E V .
N / A
1/4 Turn
1/2 Turn
3/4 Turn