Installing Levelers - GBC F - 160 CE Operation And Maintenance Manual

F - 160 CE Operation and Maintenance Manual

4.7 Installing levelers

Leveling of the machine is a customer option. If
you choose not to level the laminator and you encounter
output problems, please level the machine and try your
application again before calling for technical support.
Before leveling can be performed, the castors
must be replaced with leveling bolts and leveling pads.
Tools required
• Torpedo level
• ( 2 ) 3/4" open end wrenches
• Four leveling pads
( from the accessory pack )
• Four Leveling bolts
( from the accessory pack )
• Twelve 3/4 - 10 nuts
( from the accessory pack )
• Floor jack
( 600 pound rating )
• Second person
Control side
a) Verify that the laminator has sufficient room
around it to load film, walk around and to be
serviced if necessary.
© GBC Films Group April 2000
b) Lock the castors on the drive side leg.
CAUTION
Do not lift the machine where NO LIFT
warnings are located. You can cause
damage to the electrical bridge.
c) Slide the floor jack under the control side leg.
Center of the leg
d) Raise the control side approximately 4 in. from
the bottom of the castor to the floor. (10 cm)
Must have eneough clearance to remove the
castors
Installation
Page 4 - 9