Features Guide; Emergency-Stop Buttons; Feed Roller Idler; Front Table - GBC 2064-WF Instruction Manual

GBC 2064
FEATURES/ACCESORIES GUIDE
Refer to the following pages for detailed information on the above Features
FEATURES/ACCESORIES GUIDE (DETAILED DESCRIPTION)
Figure 1
D
C
Figure2
D
E
Figure 3
© 2006 General Binding Corporation
EMERGENCY STOP BUTTONS
(Fig. 1– Item A)
Two emergency stop buttons are available on
the Laminator on the top corners of the
Laminator.
To engage Emergency -stop button, Press any
emergency -stop safety push button to stop
the roller movement
To disengage turn the push button clockwise
after the emergency condition has been
resolved.
Media Tables: (Fig. 2 & 3)
On both the Front Media & Rear Media
tables, the safety interlock switch will not
allow the Laminator to operate at full speed
unless the tables are properly installed.
B
The Media tables are used to position items
for Lamination. There are two media tables
on the machine one on the front & one on the
rear of the Laminator. The Front Media table
incorporates an Idler on the leading edge of
A
the table. This is used for roll to roll
applications during lamination
Note:
The Laminator will operate only when the
Media Table and Media Table Latch are
Properly Installed.
The Features/Accessories Include:
A. Pressure Plate: (Fig. 2A) Used for
guiding stock and ensuring a wrinkle free
feed into the roller
B. Feed Roller Idler: (Fig. 2B) Used for
guiding Media through the laminator. The
table Idler is helpful in roll to roll operation
and helps move large ridged panels through
the nip.
C. Front Table: (Fig. 2C) Used to guide and
support images into the nip.
D. Rewind Tube: (Fig. 3D) Used to rewind
release liners or finished Medias.
E. Rear Table: (Fig. 3E) Used to support
finished Media and used when running the
machine from the rear.
Operation Manual
Page 9