GBC F - 160 CE Operation And Maintenance Manual page 41

Installation
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
j) Press PRESSURE
the pressure dsiplay.
GAP
0
k) Place the level across the top of the upper main
roller in the center. Refer to Figure 4.8.3
Drive to control side front
Figure 4.8.3 Drive to control side front
Level
Page 4 - 14
WARNING
to illuminate 3 bars in
PRESSURE
F - 160 CE Operation and Maintenance Manual
l) Level the laminator from drive side to control
side by adjusting the two front leveling pads.
- To raise; raise the nut inside the leg and turn
the nut below the leg clockwise.
Raise
Turn clockwise
- To lower; turn the nut below the leg counter
clockwise.
Lowering
limit
Turn counter
n) Press GAP
GAP
1
© GBC Films Group April 2000
clockwise
to 1 in. setting.
PRESSURE