Table of Contents
Advertisement
Installation
4.10 Safety check
The safety check will ensure that all safety devices
and interlocks are functioning properly.
This procedure describes how to check one
E-STOP, the front E-CABLE, the front safety shield
and the front feed table. Repeat the steps for the remaining
three E-STOPS, the rear E-CABLE and the rear safety
shield. The rear feed table is not removable. ALL
SAFETY FEATURES MUST BE CHECKED!
Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
If a safety feature is not working
properly, contact your local service
representative immediately.
Contacts:
GBC National Service: ( 800 ) 790 - 7787
GBC Europe Service: 33 - 45 - 535 - 7676
Page 4 - 18
WARNING
WARNING
F - 160 CE Operation and Maintenance Manual
4.10.1 Front feed table
a) Turn MAIN POWER to "ON" .
Power
ON/OFF
b) Press RESET. The front control panel will be
illuminated.
Machine reset
c) Press SEL. SEL stops flashing.
0
JOB
© GBC Films Group April 2000
SAV
S E
L
STANDBY
= Flashing
Advertisement
Table of Contents
