GBC F - 160 CE Operation And Maintenance Manual page 72

F - 160 CE Operation and Maintenance Manual
c) Press GAP to set the gap to "0".
GAP
0
INFORMATION
Do not add PRESSURE when heating the
laminating rollers. The rollers expand.
d) Press FWD to set a forward motion
direction.
00.0
SPEED
SAFETY
e) Press SPEED
( .61 m / min. ).
2.0
SPEED
SAFETY
© GBC Films Group April 2000
PRESSURE
G O
F W D
REV
STOP
to set a speed of 2 ft/min
G O
F W D
REV
STOP
INFORMATION
A slow speed helps distribute heat evenly.
f) Press SEL to engage the parameters.
0
JOB
g) Press GO to engage the motor drive system.
2.0
SPEED
SAFETY
h) When the rollers are close to it's set point value,
the temperature displays stop flashing, press
STOP and raise the gap to 1 in. by pressing
GAP
GAP
1
Operations
SAV
S E L
STANDBY
G O
F W D
REV
STOP
PRESSURE
Page 5 - 15