Adding An Expansion Card - Gateway 8450R System Manual

Adding an expansion card

The server supports as many as two 32-bit, 33 MHz PCI expansion cards. These
cards are not hot-swap cards and you must turn off the server before installing
one.
To install an expansion card:
1
Set any jumpers and switches on the replacement card, if required in the
card instructions.
2
Turn off the server, then disconnect the power cord and all external
peripheral devices.
3
Remove the back top panel according to the instructions in "Removing
the back top panel" on page 28. (See "Preventing static electricity
discharge" on page 25.)
4
Remove the EMI foam cover over the processors.
80
Replacing and Adding Internal Devices