Chapter 2 Phone Installation; Install Phone Battery - Cisco 7925G User Manual

Phone Installation
Your system administrator configures your new Cisco Unified Wireless IP Phone to connect to the corporate
wireless network and the IP telephony network.
A rechargeable Lithium ion battery powers the Cisco Unified Wireless IP Phone. Before you can use your
phone, you must install the battery in the phone and charge the battery. Depending on the type of battery
you have, the fully charged battery provides the following hours of service:
• The standard battery provides up to 9.5 hours of talk time or up to 180 hours of standby time.
• The extended battery provides up to 13 hours of talk time or up to 240 hours of standby time.
Using a Bluetooth wireless headset reduces the talk time and standby time for both types of batteries. In
Note
addition, how the system administrator configures your phone also affects its battery life. For more
information, contact your system administrator.
•
•
•
•
•
•

Install Phone Battery

This section describes how to install the phone battery.
Procedure
Step 1 To remove the phone cover, follow the steps in the following figure.
Install Phone Battery, page 17
Phone Battery Charging, page 20
After Battery Is Charged, page 23
Set Username and Password, page 24
Register with TAPS, page 25
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Accessories, page 25
C H A P T E R
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G User Guide
2
17