Undock Phone; Change Charger Speaker Volume; Charge Spare Battery - Cisco 7925G User Manual

Undock Phone

c) Pair the charger and phone again.
Related Topics
Pair Charger and Wireless Phone, on page 119
Undock Phone
Procedure
To undock the phone, remove the phone from the cradle.
If you are on a call when you undock the phone, the Power/Bluetooth Status LED flashes blue while the Cisco
Unified Wireless IP Phone 7925G Desktop Charger disconnects. The call then continues on the phone.

Change Charger Speaker Volume

Procedure
Use the volume keys on the phone to raise or lower the speaker volume.

Charge Spare Battery

Use this procedure to install a spare battery so that it can be recharged. After the spare battery is fully charged,
you can use it as a power source (for a limited time) for the Cisco Unified Wireless IP Phone 7925G Desktop
Charger.
Prerequisites
• The Cisco Unified Wireless IP Phone 7925G Desktop Charger must be plugged into the electrical outlet.
Procedure
Step 1
Insert the spare battery into the Cisco Unified Wireless IP Phone 7925G Desktop Charger as shown in the
following figure. The battery contacts must be facing the base of the charger.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G User Guide
122
Cisco Unified Wireless IP Phone 7925G Desktop Charger