Use Push To Talk Service; Java Midlets; Bar Code Scanner - Cisco 7925G User Manual

Applications
Instructions for accessing Push to Talk depend on your system:
• for systems using Cisco Unified Communications Manager Release 4.3 or later, see
• for systems using Cisco Unified Communications Manager Release 5.0 or later, see

Use Push to Talk Service

Procedure
Step 1
Choose
Push to Talk service is active when the
Step 2
Use the
Step 3 Use the Talk and Stop softkeys to toggle between transmitting and listening.

Java MIDlets

Java MIDlets are special applications that provide you with specific services. An example of a MIDlet would
be the Bar Code Scanner application that is used by the Cisco Unified Wireless IP Phone 7926G.
To use a MIDLet, you need to subscribe to the service. To access a MIDlet, you press the Applications button
(on the left side of the phone).
Your administrator can set up a MIDlet to automatically launch when you turn on the phone. The MIDlet
starts and then minimizes to the background until you need to use it.
You can manually stop the launched MIDlet. To start the MIDlet later, you either launch the MIDlet or turn
the phone off and on.
For more information, contact your system administrator.

Bar Code Scanner

Your system administrator can configure the Cisco Unified Wireless IP Phone 7926G to scan bar codes using
the scanning module on the top of the phone. The phone uses a Java MIDlet to read the bar code data and
display information such as pricing, location, and inventory information. Contact your system administrator
for information about using the bar code scanner.
Note The Cisco Unified Wireless IP Phone 7926G must be running Firmware Version 1.4(1) or later to support
the bar code scanner.
Subscriptions, on page 126
Setup on Web, on page 134
> Push to Talk (name can vary).
button to start and end a transmission depending on how your service is configured.
icon appears.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G User Guide
Java MIDlets
Phone Services
Phone Services
91