Printer Problems - Gateway 7450R System Manual

The system does not recognize an expansion card
Probable cause
The interrupt or I/O
address is set incorrectly
The card has not been
configured through the
software
The card was not installed
correctly

Printer problems

This server does not include a parallel port on the I/O panel. To connect a
printer directly to the server, you must use a serial or USB printer.
The printer will not turn on
Probable cause
The printer is not onlne
(ready)
The printer is not turned
on
The printer is not
plugged in
The printer is defective
The printer is turned on but will not print
Probable cause
The printer is not connected
to the system
84
Gateway 7450R Server System Manual
Solution
Check the address configuration of the adapter card and
make sure that it does not conflict with another card in the
system.
Configure the card with the appropriate software.
Make sure the card jumpers are set correctly and reseat
the card.
Solution
Make sure the on-line or ready light is on, or the display
indicates "Ready."
Make sure that the power switch is set to the On position.
If the printer is turned on, the green power LED should be
illuminated.
Make sure that the power cable is plugged into a working
power source.
Try another printer, if one is available.
Solution
Make sure the data cable between the printer and the
system is properly connected. Make sure that it is
connected to the proper port. Make sure the connector
and cable have no bent or broken pins.