Table of Contents
Advertisement
Changing the SCSI ID settings
To change the SCSI ID settings:
1
From the main menu, press the P
Configuration
2
Press E
NTER
3
Press the P
LCD.
4
Press E
NTER
5
Press the P
6
Press E
NTER
7
Press the P
8
Press the E
9
Turn off the autoloader. Wait a few seconds, then turn the autoloader on
again. The selected SCSI ID is now set.
Important
SCSI cable requirements
We recommend using 68-pin SCSI cables that conform to SCSI-3 specifications.
Warning
appears on the LCD.
to select the
Configuration
or N
button until Change SCSI ID appears on the
REVIOUS
EXT
to select the
Change SCSI ID
or N
button until Loader or Drive appear on the LCD.
REVIOUS
EXT
to select the
Loader
or N
button until the SCSI ID you want appears.
REVIOUS
EXT
button. Cycle Power for New SCSI ID appears on the LCD.
NTER
If you change the SCSI ID, you may also need to turn the
host server off and on, and reconfigure your backup
program before you can use the autoloader. The
autoloader and the tape drive must each have unique
SCSI IDs. Make sure that you do not assign duplicate IDs
within a bus.
All wide SCSI configurations (single-ended, LVD, and
HVD) use the same 68-pin connector. Attaching the
autoloader directly to an HVD SCSI will make the entire
bus non-functional and may permanently damage the drive
or other SCSI devices on the bus.
www.gateway.com
or N
button until
REVIOUS
EXT
menu.
option.
or
option.
Drive
SCSI interface
53
Advertisement
Table of Contents
