Table of Contents
Advertisement
Chapter A:
Vibration specifications
The following table shows the vibration specifications for the autoloader during
operation, non-operation, storage, and transportation. The operating
specifications indicate the amount of vibration the autoloader can withstand
while the enclosed tape drive is reading and writing data.
Random vibration (1) applied during operation
1 Hz
5 Hz
10-150 Hz
200-400 Hz
Random vibration (2) applied during non-operation (3) and storage (4)
1 Hz
3 Hz
12-100 Hz
400 Hz
Transportation (4)
ISTA Procedure 2A
Swept sine applied during non-operation (5) and operating (6)
5 to 500 to 5 Hz
(1) A 0.3 g rms random vibration spectrum is applied to the bottom/top axis for a
(2) A 1.06 g rms random vibration spectrum is applied to each of three orthogo-
(3) The autoloader has been unpacked, but is not operating.
(4) The autoloader is packaged in its original shipping container.
(5) Three sweeps at one octave per minute are applied to each axis at 0.75 g
(6) Three sweeps at one octave per minute are applied to the top/bottom axis at
60
PSD = 0.0000040 g2/Hz
PSD = 0.0000270 g2/Hz
PSD = 0.0004048 g2/Hz
PSD = 0.0001079 g2/Hz
PSD = 0.0003 g2/Hz
PSD = 0.00055 g2/Hz
PSD = 0.01 g2/Hz
PSD = 0.000003 g2/Hz
minimum of 20 minutes per axis.
nal axes for a minimum of 20 minutes per axis.
(0 . peak) input.
0.3 g (0 . peak) input.
www.gateway.com
Advertisement
Table of Contents
