Table of Contents
Advertisement
Chapter 3: Setting Up the Autoloader
Installing the autoloader into a
cabinet
The autoloader can be installed into an EIA 310-D standard 19-inch cabinet
(rack).
Requirements
To install the autoloader into a cabinet, you need:
#2 Phillips screwdriver
TORX T-10 screwdriver
The included cabinet mount kit — Make sure that the cabinet mount kit
contains the following items:
Support rails
18
Two support rails
Two cabinet mount brackets
Ten screws
Ten clip nuts
www.gateway.com
Cabinet mount brackets
Screw
Clip nut
Advertisement
Table of Contents
