Table of Contents
Advertisement
Chapter 3: Setting Up the Autoloader
Choosing a location
Choose a location that meets the following criteria:
Select a location that is flat, sturdy, level, and close to the host server. Do
not place the autoloader on the floor or other carpeted surfaces.
Warning
Cabinet (rack) requirements — EIA 310-D standard 19-inch cabinet with
2U of clearance
Room temperature — 50 to 95ºF (10 to 35ºC)
Power source — AC power voltage: 100-127 VAC; 200-240 VAC line
frequency: 50-60 Hz
Important
Air quality — Minimal sources of particulate contamination. Avoid areas
near frequently used doors and walkways, stacks of supplies that collect
dust, printers, and smoke-filled rooms.
Warning
Humidity — 20 to 80% RH non-condensing
Clearance — Back: minimum of 6 inches (15.4 cm). Front: minimum of
12 inches (30.8 cm). Sides: minimum of 2 inches (5.08 cm).
Important
16
Do not place the autoloader on its side or upside down,
or stack items that weigh more than 33 lbs. (15 kg) on top
of the autoloader.
Locate the AC outlet on the back of the autoloader. The
power cord is the autoloader's main AC disconnect device
and must be easily accessible at all times.
Excessive dust and debris can damage tapes and tape
drives.
Save all the original packing materials, including the
accessory box, in case you need to ship or move the
autoloader at a later time.
www.gateway.com
Advertisement
Table of Contents
