Table of Contents
Advertisement
Chapter 2: Quick Start
3
Use the eraser end of a pencil, or something similar, to press the left side
of the power switch. The autoloader turns on.
Important
When you turn on or reset the autoloader, it runs an initialization routine.
During initialization, the Operator's Panel displays progress information.
After initialization, the autoloader displays the mount status for the current
drive and displays SEQ to indicate that the sequential mode is ON.
In addition, the appropriate inventory status characters appear. For more
information, see "Inventory status characters" on page 33.
4
Start the host computer system.
12
The power switch lets you turn the autoloader and the
enclosed tape drive on or off. The power switch is recessed
into the front panel to prevent the autoloader from being
accidentally turned off during operation.
www.gateway.com
Advertisement
Table of Contents
