GarrettCom Magnum ES42 Series Installation And User Manual page 15

ES42 Series Edge Switches
Port Connectors:
RJ-45 Ports: support 100BASE-TX and 10BASE-T with auto-cross (MDIX).
They are shielded 8-pin female connectors for shielded (STP) and unshielded
(UTP) Cat 3, 4, 5 cable.
One Fiber optic port: On the ES42 Series it is 100Base-FX with a "fiber flavor"
choice of multimode SC, ST, LC or MTRJ or single mode SSC, SSCL, SST or
SLC connectors. (By default factory settings is at "Full" duplex on fiber ports)
LED Indicators (Front)
POWER: Steady ON when power applied
10/100: Steady ON for 100Mbps; OFF for 10 Mbps(copper ports only)
LK/ACT: Steady ON for LINK (LK) with no traffic, BLINKING indicates
F/H:
www GarrettCom com . .
port is transmitting / receiving (ACT).
Steady ON for full-duplex, OFF for half-duplex (Fiber port only)
8
Installation and User Guide (05/05)