Attaching Power Supply And Powering On - MakerBot Replicator 2x User Manual

ATTAChiNg POwEr SUPPLy AND POwEriNg ON

Attaching the Power Supply
10
10a. Locate the power supply and cable.
Attach the cable to the power supply.
10b. Ensure that the power switch on
the MakerBot Replicator 2X is set to the
OFF position.
10c. Insert the power supply connector into
the power input port on the back of the
MakerBot Replicator 2X. Ensure that the
flat side of the connector faces down.
NOTE: If at any time you need to unplug the
MakerBot Replicator 2X, pull on the connector
itself to release it from the power input port.
Powering On the MakerBot Replicator 2X
11
11a. Plug the AC power cord into an
electrical outlet.
11b. Set the power switch to the
ON position.
11c. The MakerBot Replicator 2X will display
welcome text on the LCD panel. This is the
beginning of the startup script that will
guide you through initial calibration and
your first 3D print.
NOTE: The socket-outlet shall be installed near
the equipment and shall be easily accessible.
B SETTING UP YOUR MAkERBOT REPLICATOR 2X EXPERIMENTAL 3D PRINTER
Power Supply
19