Installing Enclosure Door Handle - MakerBot Replicator 2x User Manual

iNSTALLiNg ThE ENCLOSUrE DOOr hANDLE
Installing the Enclosure Door Handle
5
5a. Locate the handle kit in the Accessory
box. The kit includes your enclosure door
handle and two buttonhead bolts.
5b. Open the enclosure door. To do this,
reach through the top of the MakerBot
Replicator 2X, push the door outward,
and raise it to a 90° angle.
5c. Place the handle on top of the enclosure
door. Align the holes in the ends of the handle
with the pre-drilled holes in the enclosure door.
5d. Use your fingers to thread each bolt
through the holes in the enclosure door and
the handle. Use a Phillips head screwdriver to
tighten the bolts. Close the enclosure door.
B SETTING UP YOUR MAkERBOT REPLICATOR 2X EXPERIMENTAL 3D PRINTER 15