AOR AR7000 Manual page 6

{figure 2}
7.2.1 AUX connector
This 8-pin 270º DIN socket provides output for audio, squelch switching, etc. Refer
to section 10 of this manual for pin-out details.
7.2.2 Video output switch
This slide switch selects the video format of either PAL or NTSC. The default
position is NTSC. Note: When PAL is selected the built-in LCD is disabled.
7.2.3 Video output terminal
This PHONO socket provides a composite video output to the external monitor in
either NTSC or PAL depending upon selection.
7.2.4 Audio output
This PHONO socket provides audio output to external equipment (such as a
camcorder etc). The output level is constant irrespective of the volume control
setting.
7.2.5 Aerial (antenna) terminal
A BNC type connector is provided for aerial connection. A 50 OHM impedance aerial
is recommended for this receiver. If wire aerial is connected any suitable Balun may
be used for optimum results.
7.2.6 RS232C Connector
A D-SUB 9-pin connector is provided for straight lead connection with most types of
PC via an RS232C connection. Refer to section 9 of this manual for connection
information.
7.2.7 DC socket
Connect the supplied a.c.-d.c. adapter to this socket. The applicable standard for the
jack/plug is RC5320A(EIAJ)/IEC13010. This plug/socket is wired centre positive, if
using a different power supply, select a unit which is regulated producing 12 to 14V
d.c. with a current capacity of at least 2.0A.
7.2.8 External speaker socket