Priority; Display - AOR AR7000 Manual

are involved. The more erratic the transmission, the longer the squelch tails should
be.
{figure 131}

6.6 Priority

Any one of 1500 memory channels can be designated as priority channel.
6.6.1 Priority time
In the "Configuration" menu screen, place the cursor alongside "PrioTime" followed
by [ENT]. Rotate the main dial or push the [ keys to select the desired value
followed by [ENT]. Priority time is selectable between 1 second and 60 seconds in
increments of 1 second. Select OFF if the priority facility is not required.
The AR7000 will check for activity on the priority channel every few seconds as set in
priority time (unless disabled by selecting OFF). If a transmission is encountered on
the priority channel, the AR7000 will monitor the traffic. Of course valid data must be
stored in the nominated priority channel.
{figure 132}
6.6.2 Priority channel
In the "Configuration" menu screen, place the cursor alongside "PrioCh" followed by
[ENT]. Rotate the main dial to select (nominate) the desired memory channel/bank,
use the [ keys to toggle between BANK and CHANNEL number. Accept the
input by pressing [ENT].
{figure 133}
7 Name editor
Each memory channel or program search/scan can be given a specific name via the
name editor menu screen.
7.1 Display screen and descriptions
Refer to the following examples:
{figure 134}
1. Input line
The name you are writing will be displayed on this line, a maximum of 7 characters
may be entered.