AOR AR7000 Manual page 20

Press the [EDIT] key to select the memory function menu. While the ">" cursor is
along side the menu item "Ch Edit/Del", press the [ENT] key. The memory edit
menu will be displayed, a quick press of the [ or keys will highlight the
CHANNEL (00 to 99) and BANK numbers (00 to 14) as a toggle by displaying a
negative image over the required selection (do not hold the arrow keys too long, just
a quick press is required).
Rotate the main dial to scroll through memory channel numbers or bank numbers as
appropriate. Memory channels with no valid data or items with no specific data
stored will be displayed as "- - - -".
B Selection of data to edit
While in the memory edit menu, press the [ ] or [ ] key to move the red cursor ">" to
the position where you wish to edit (frequency, mode, IF-BW, Name, Ch Pass, Ch
Delete) followed by [ENT].
B-1 Change of frequency
Place the cursor ">" along side the receive Frequency followed by [ENT]. The
present frequency will change to a negative image. Tap in the new desired
frequency via the numeric keypad followed by [ENT].
{figure 51}
B-2 Change of receive mode
Place the cursor ">" along side the receive Mode followed by [ENT]. The present
receive mode will change to a negative image. Either rotate the main dial or press
the [ or keys until the desired receive mode appears (USB, LSB, CW1, CW2,
CW3, AM, NFM, WFM, AUT). Press [ENT] to confirm your selection.
{figure 52}
B-3 Change of IF-BW
Place the cursor ">" along side the IF-BW followed by [ENT]. The IF-BW will turn to
a negative image. Either rotate the main dial or press the [ or keys until the
desired IF-BW appears (the selection available depends on current receive mode).
Press [ENT] to confirm your selection. When AUT has been selected as the current
receive mode, IF-BW will be automatically selected by the AR7000 CPU mapped
band plan, for this reason you cannot change the IF-BW when AUT receive mode is
selected, the IF-BW will display "- - - -" and cannot be changed.
{figure 53}
B-4 Change of text/ident
Place the cursor ">" along side the test ident Name followed by [ENT].