Dial Mode; Display - AOR AR7000 Manual

away from adjacent channel interference, especially on the short wave and medium
wave bands.
{figure 36}
Operating the IF Shift
Press the [IF SFT] key, the IF SHIFT legend will reverse to a negative image to
confirm selection.
Each press of the [IF SFT] key will toggle the status between current value and OFF.
Either rotate the main dial or press the [ or [ keys to vary the IF shift frequency
as required. Press the [ENT] key when the optimum IF Shift frequency is obtained.

2 Dial Mode

Both types of dial mode (VFO-A) and (VFO-B) operate in exactly the same manner.
Both are referred to here as dial mode.

2.1 Display

An example of the LCD display is shown here when dial mode is selected.
{figure 38}
Note: Mch 03/02 represents the memory channel number 3 on the memory bank
number 2.
2.2 Frequency Selection
Direct entry via key-pad
Push the numeric keys to enter the frequency in a MHz order followed by [ENT], use
the decimal point after the MHz entry such as [8] [1] [.] [3] [ENT] for 81.300 MHz,
there is no need to use proceeding or trailing zeros.
{figure 39}
Tuning via the main dial
Rotate the main dial while in dial mode to tune through the frequency spectrum at
the pre-determined step size. Clockwise rotation increases frequency while ant-
clockwise rotation decreases frequency.
2.3 Selection of frequency step
The step size cannot be altered while the AR7000 is in AUTO MODE (while the
legend "AUT" displayed on the LCD), select another receive mode then press the
[STEP] key.
The step frequency legend will reverse to negative image. Tap in an appropriate
step size via the key-pad using kilo Hertz format (thousands of Hz) followed by [ENT],